Template:R2 Dome
{{{1}}} Dome
R2 Series Dome Requirements | ||||
|---|---|---|---|---|
| Dome | ||||
|
Ref# | Name | Color | Notes |
| BC | Dome Base Color | {{{basecolor}}} | ||
| DB1 | Dome Button 1 | {{{paccentcolor}}} | ||
| DB2 | Dome Button 2 | {{{paccentcolor}}} | ||
| HP1 | Holo Projector 1 | Aluminum | ||
| HP2 | Holo Projector 2 | Aluminum | ||
| HP3 | Holo Projector 3 | Aluminum | ||
| PP1 | Pie Panel 1 | {{{paccentcolor}}} | ||
| PP2 | Pie Panel 2 | {{{paccentcolor}}} | ||
| PP3 | Pie Panel 3 | {{{paccentcolor}}} | ||
| PP4 | Pie Panel 4 | {{{paccentcolor}}} | ||
| PP5 | Pie Panel 5 | {{{paccentcolor}}} | ||
| PP6 | Pie Panel 6 | {{{paccentcolor}}} | ||
| P1 | Panel 1 | {{{paccentcolor}}} | ||
| P2 | Panel 2 | {{{paccentcolor}}} | ||
| P3 | Panel 3 | {{{paccentcolor}}} | ||
| P4 | Panel 4 | {{{paccentcolor}}} | ||
| P5 | Panel 5 (Magic Panel) | {{{paccentcolor}}} | ||
| P6 | Panel 6 | {{{paccentcolor}}} | ||
| P7 | Panel 7 | {{{paccentcolor}}} | ||
| P8 | Panel 8 | {{{paccentcolor}}} | ||
| P9 | Panel 9 | {{{paccentcolor}}} | ||
| P10 | Panel 10 | {{{paccentcolor}}} | ||
| P11 | Panel 11 | {{{paccentcolor}}} | ||
| P12 | Panel 12 | {{{paccentcolor}}} | ||
| P13 | Panel 13 | {{{paccentcolor}}} | ||
| P14 | Panel 14 | {{{paccentcolor}}} | ||
| RE1 | Radar Eye | {{{paccentcolor}}} | ||
| TP1 | Top Panel | {{{paccentcolor}}} | ||
| DR | Dome Ring | {{{paccentcolor}}} | ||
| Additional Dome Notes: | ||||
Pie Panels: R2 units have six pie panels on the top of the dome. One of the pie panels must have a Holoprojectors (HPs) installed on it in the proper location.
Template:R2DomePanels
Radar Eye should sit approximately 2.647" (vertical height) from the base of the outer dome. This is the most iconic and distinctive piece of the dome and provides the face of the droid.
Radar Eye Lens should fit cleanly and flush within the opening for the Radar Eye which has a diameter of 3 inches. The lens should not be clear.
Front Logic Display: Two of these are vertically stacked on the dome. These combine multiple components such as electronics, surrounds, and bezels. There should be at least 45 individual leds in a 5x9 array. The standard LED color used is WHITE and BLUE. Additionally, a Front Logic Display surround must be present. Not required but recommended is the use of logic bezels to provide better spacing of the LEDs.
Rear Logic Display (RLD):
Front PSI (Process State Indicator):
Rear PSI (Process State Indicator):
Dome Bumps There are two on the standard R2-unit on the back of the dome, just above and to the right of the rear PSI.:
Magic Panel:
Dome Ring: